Skylight / July 10, 2018 / Faye Savoie.
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.
After the hole is cut the skylight frame is simply attached to the roof sheathing with L-brackets and then the installation is completed using the factory-supplied flashing kit. Ease of installation superior insulating qualities less tendency to scratch and a cleaner finished appearance all add to the popularity and somewhat higher cost of glass skylights. Glass skylights also have a greater number of optional accessories. These include tempered laminated or wire glass; shades and blinds for light control; glass tints for heat retention or to block sunlight; and the ability to open fully or partially for ventilation. Domed acrylic skylights are less expensive than glass.
This is ideal for cubicles or small offices even restrooms. The places where tubular skylights are most effective are in the bottom floor of a multi-story building in order to light the space with natural sunlight warehouses private offices or to prevent heat loss and for solar gain. The installation of tubular skylights requires a professional installer who can work with the thickness of your ceiling and angles to get the most out of your skylight. The top panel of the skylight will be affixed to your roof with the channel running through the ceiling completely hidden from sight with the bottom window attached on the visible area of the ceiling.
The acrylic dome is typically mounted in an aluminum frame which is in turn mounted on a box called a "curb." Once the hole is cut in the roof to the manufacturers specifications the curb is typically constructed on-site to raise the skylight above the level of the roof sheathing. Site-built or factory-supplied flashings are used to seal the roofing around the curb. Domed skylights are available in clear smoked bronze or other tints. Some domed plastic skylights are flush mounted which means that the lens piece and flashing piece are both made of plastic and then placed on the roof without a curb. The problem with this type is that they are loud and very susceptible to leakage.