Skylight / July 8, 2018 / Baptiste Allain
Solar heat control glazing - Manufacturers use various glazing methods to reduce the impact of summer time solar heat gains and winter time heat losses. These come in the form of heat-absorbing tints double and tripled paned skylights and low-emissivity coatings. Slope When your window professional installs your skylight one of the factors they will take into consideration is the slope. The slope or tilt of the skylight affects the amount of solar heat gain. A low slope on your skylight admits more solar heat in the summer and less in the winter which is the opposite of the effect you are trying to achieve As a rule of thumb you want to achieve a slope equal to your geographical latitude plus 5 to 15 degrees.
For one thing skylights are positioned in such a way that they are inaccessible unless they are operated by remote. Even in cases of motorized skylights which are easily manipulated there are still some disadvantages that are inherent to skylights that are not present or minimized in windows. Vertical windows lose less heat by convection when compared to skylights. Also since windows are generally protected by overhangs or shrubs they lose less heat by radiation. On the other hand skylights are directly exposed to the sky. Thus they lose more heat by radiation. Proper insulation can reduce this heat loss to a large extent. In the summer season skylights are more exposed to the direct heat of the sun than windows.
You will need to position and mark the opening on the ceiling after the skylight is installed. Take into consideration the size of the room and the amount of light you wish to bring in and select the size and position of the hole accordingly. Once the skylight is installed and the ceiling hole is cut its then a matter of connecting the two with the shaft which is typically constructed from 2x4 or 2x6 lumber. The angles involved typically require some tricky framing and is probably best left to an experienced carpenter. After the framing is completed the inside of the shaft is covered with wood or drywall and the attic side is insulated to minimize heat loss.